Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. MATERIAL DATA
SETTING AND DISPLAY OF DATA
241
1) Cutting condition for turning
Division
Cutting
speed
Feed rate
Cutting
depth
Division
V
F1 F2 F3 F4 D
CENTER DRILLING f f
DRILLING f f
REAMING f f
TAPPING f
ROUGH FACING
ROUGHING OF OUTER FIGURE
ROUGHING OF INNER FIGURE
f f f f f
SEMI–FINISHING FACING
SEMI–FINISHING OF OUTER FIGURE
SEMI–FINISHING OF INNER FIGURE
f f
FINISHING FACING
FINISHING OF OUTER FIGURE
FINISHING OF INNER FIGURE
f f f f f
GROOVING FACING
GROOVING OF OUTER FIGURE
GROOVING OF INNER FIGURE
f f f
THREADING FACING
THREADING OF OUTER FIGURE
THREADING OF INNER FIGURE
f f
CUT OFF f
(2 kinds)
f f
2) Cutting condition with high speed tool in milling machining
Cutting Feed amount (*)
Division
speed
V
FR (Diameter
direction)
FT (Axis
direction)
Center drill f f
Drill f f
Tap f
End mill (*) f f f
(*) Set the feed amount per one blade in case of end mill.
3) Cutting condition with the carbide tool in milling machining.
It is the same as (2).
CAUTION
The increment system of the cutting speed is m/min or
feet/min.
The increment system of the feed rate is mm/rev or inch/rev.
The increment system of the infeed amount is mm or inch.
1.2
SETTING AND DATA
WHICH CAN
DISPLAYED

Leave a Reply

Your email address will not be published. Required fields are marked *