Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
1. MATERIAL DATA
242
Initial screen
=0= PARAMETER & DATA SET =0=
Menu screen
“End”
DATA
SET
3 INPUT
*** PARAMETER & DATA SET *** MATERIAL
NO. SAMPLE OF MATERIAL
1 S45C
2 SCM
3FC
4AL
5 SUS
Register the number by CURSOR ± or CURSOR °
Material name to be registered INPUT (Note 1)
(1) Cutting condition page for turning (No. 1)
Set various conditions on questions.
±NEXT PAGEBACK PAGE°
(2) Cutting condition page for turning (No. 2)
(3) Cutting condition page with high speed tool for C–axis
machining
(4) Cutting condition page with carbide tool for C–axis
machining
“End”
“End”
“End”
Directory of registered
material name
±NEXT PAGEBACK PAGE°
±NEXT PAGEBACK PAGE°
NOTE
Material name shall be within 10 characters. If a material name is already registered at the
position shown by the cursor, the material name newly input is inserted to the cursor position.
Then the material name at the cursor position or subsequent shifts lower one by one.
1.3
OPERATION
METHOD
1.3.1
Method of Registration

Leave a Reply

Your email address will not be published. Required fields are marked *