Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
2. TOOL DATA AND TOOLING
INFORMATION
248
WARNING
The tool data, described below, varies with the machine.
For details, refer to the manual provided by the machine tool
builder. If tool data values are not set appropriately for the
actual machine being used, correct NC data cannot be
prepared. Machining with incorrect NC data may result in
the tool colliding with the workpiece, or forced machining
occurring, possibly causing damage to the machine and/or
tool itself, or injury to the user.
1) Press the DATA SET soft key on the initial screen. The parameter
and data setting menu screen will be displayed.
2) NO = will be prompted, so key in “1”, “INPUT”, and the system data
setting menu screen will be displayed.
3) NO = will be prompted, so key in “9”, “INPUT”, and the tool data
list screen will be displayed.
On the tool data list screen, the tool management number and the tool type
are shown per list number.
Meaning of Soft Keys
MILLING TOOL The milling tool list screen is displayed. . . . . . .
SEARCH NO Used to search for a list number. . . . . . . . . .
In response to the prompt NO = in the
lower part of the screen, input the value of
the list number of the tool to be searched for
and then press SEARCH NO, and the
cursor will move to that number.
DATA SET The tool data detail setting screen is. . . . . . . . . . .
displayed.
“CURSOR ° The cursor indicating the list number. . . . . . . . . . .
“CURSOR ± moves up/down.
“END” Press to end the setting. The system data. . . . . . . . . . . . . . . .
setting screen is returned to.
Press the SET DATA soft key. Then, the tool data detail setting screen
appears.
2.2
TOOL DATA DISPLAY
AND SETTING

Leave a Reply

Your email address will not be published. Required fields are marked *