Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
2. TOOL DATA AND TOOLING
INFORMATION
250
Tool management number ID = . . . . . . . . . . . . .
Tool type TP = . . . . . . . . . . . . . . . . . . . . . . . . . .
Process type KP = . . . . . . . . . . . . . . . . . . . . . . . .
Tool tip radius RN = . . . . . . . . . . . . . . . . . . . . . .
Cutter angle AC = . . . . . . . . . . . . . . . . . . . . . . . .
Tool tip angle AN = . . . . . . . . . . . . . . . . . . . . . . .
Tool tip width WN/DD = . . . . . . . . . . . . . . . . . . . . . . .
Virtual tool tip position XN = . . . . . . . . . . . . . . .
ZN =
Cutter protective angle AP = . . . . . . . . . . . . . . . .
Setting angle AS =. . . . . . . . . . . . . . . . . . . . . . .
Setting position XS = . . . . . . . . . . . . . . . . . . . . .
ZS =
X–mirror image XM = . . . . . . . . . . . . . . . . . . . . .
Spindle rotating direction SD = . . . . . . . . . . . . . .
Holder number HL =. . . . . . . . . . . . . . . . . . . . . .
1: center drill; 2: drill;
3: grooving/necking;
4: thread; 5: general;
8: finger; 9: reamer; 10: tap
Automatic process decision
function prompt
Pitch it tap
Tool tip width if grooving tool
Drill diameter drill
Tool diameter if reamer, tap
Cutter length if reamer, tap
Biting length if reamer, tap
Setting prompts below
Tool rest type
XM = 0 ordinary lathe
XM = 1 Xaxis reversible
lathe (chasing tool rest, etc.)
Animation–drawing function
prompt
CAUTION
The setting angle (AS) follows the system parameter No.200
drawing format.
(2)In case of the milling tool
See the chapter about the Caxis FAPT function in Part VIII.
(Functions of the soft keys)
[COPY ID.No.] Used when copying contents of tool data already.
set.
First set the tool identification number of the data
to be copied. Check that the tool identification
number is correctly set, and press this soft key.
[UNDEFINE] Used to delete all tool data already set. . .
When data must be partially undefined, key in
DEL
INPUT
.
If this soft key was pressed by mistake, set the
former tool identification number only, and press
the COPY (ID. NO.) soft key.
[LAST TOOL] [NEXT TOOL] The screen changes to the data.
setting screen of the tool
preceding the current tool ID
number or of the tool following
the current tool ID number.

Leave a Reply

Your email address will not be published. Required fields are marked *