Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
2. TOOL DATA AND TOOLING
INFORMATION
252
As mentioned in the previous section, the tool data can be set and
corrected via the MDI & CRT keys. They can also be input/output or
collated with the floppy cassette or FA card.
(Operation)
Initial screen
... PARAMETER & DATA SET
Menu screen
Output
DATA
SET
*** SYSTEM DATA SETTING & OUTPUT/INPUT ***
1. SYSTEM PARAMETER SETTING
2. SYSTEM PARAMETER OUTPUT
3. SYSTEM PARAMETER INPUT
4. SYSTEM PARAMETER COLLATING
5. MTF SETTING
6. MTF OUTPUT 13. SETTING DATA OUTPUT
7. MTF INPUT 14. SETTING DATA INPUT
8. MTF COLLATING 15. GRAPHIC DATA OUTPUT
9. TQOL DATA SETTING 16. GRAPHIC DATA INPUT
10. TQOL DATA OUTPUT
11. TQOL DATA INPUT
12. TQOL DATA COLLATING 0. END
INPUT
1
Input Collation
10, B
or
10, F
INPUT
INPUT
11, B
INPUT
12, B
INPUT
For details of operation, see CHAPTER IV.
2.3
INPUT/OUTPUT AND
COLLATION OF TOOL
DATA

Leave a Reply

Your email address will not be published. Required fields are marked *