Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
2. TOOL DATA AND TOOLING
INFORMATION
256
“CURSOR ³ The cursor moves the setting data to the. . . . . . . . . .
“CURSOR ² right/left.
NEXT TURRET Displayed if there are more than 1 tool rests.. . . . . . .
Displays the tooling information of the next
tool rests.
“END” Press to end the setting. The parameter and. . . . . . . . . . . . . . . .
data setting screen is returned to.
When the SET DATA soft key is pressed, the tooling information detail
setting screen appears.
As the tool configuration data, the data in the tool data is displayed from
the input tool management number (ID).
Also the content of the displayed data differs according to the tool type.
Tool offset number TM = . . . . . . . . . . . . . .
Tool management number ID = (Note). . . . . . . .
NOTE
The tool management number (ID) to be input must have
been registered in the tool data. If a number not registered
in the tool data is input, a message This ID is not registered
in tool data. is displayed. Also the registered ID is deleted
from the tooling information if “DEL”, “INPUT” are keyed in.
Input TM within 2 digits and ID within 3 digits.
If the tool management number (ID) is input, the tool registered in the tool
data is tooled and tool configuration data and setting data are set.
The tool figure as shown below is not displayed for 5700 series of 16–T
CAP II.
(1)Turning Tools
(Center drill)
Tool type TP; center drill
Tool tip angle AN;
Drill diameter DD;

Leave a Reply

Your email address will not be published. Required fields are marked *