Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
2. TOOL DATA AND TOOLING
INFORMATION
258
Setting Data Prompts (Common to all tool types)
Setting angle AS = (Caution). . . . . . . . . . . . . .
Setting position XS = . . . . . . . . . . . .
ZS =
X–mirror image XM= Tool resEt type. . . . . . . . . . .
XM=0 ordinary lathe
=1 Xaxis reversible lathe
(chasing tool rest, etc.)
Spindle rotating direction SD = . . . .
Holder number HL = (Note). . . . . . . . . . . .
CAUTION
The setting angle (AS) follows the system parameter
No.200 drawing format. Not displayed if the center drill, drill,
finger tool.
NOTE
The holder number (HL) prompt is displayed if the optional
animation–drawing function is available.
Tool figure of reamer tool, tap tool
(2)Milling tools
See the chapter about the Caxis FAPT function in Part VIII.
Meaning of Soft Keys
LAST TOOL Used to display the data setting screen of the last. . .
NEXT TOOL tool management number (TN) or the next tool
management number to the current display.
“CURSOR ° Used to move the prompt cursor up/down.. . . . .
“CURSOR ±
“END” Press to end the setting. The tool data list screen. . . . . . . . . .
is returned to.

Leave a Reply

Your email address will not be published. Required fields are marked *