Fanuc Symbol CAPi T Operators Manual

SETTING AND DISPLAY OF DATA
B–63304EN/02
2. TOOL DATA AND TOOLING
INFORMATION
282
(a) Tool figure
Input dimensions, referring to the following figures, irrespective of
whether the outer diameter cutting or inner diameter cutting is
done. Assume that a tool was placed on paper with its mounting
face to an NC lathe turned upward, regardless of the front face or
rear face of the cutting tool.
The “AC” plus direction is counterclockwise around the major
cutting edge as the center, while the “AN” plus direction is
clockwise around the major cutting edge as the center. (The bold
line in the figure shows the major cutting edge.)

Leave a Reply

Your email address will not be published. Required fields are marked *