Fanuc Symbol CAPi T Operators Manual

AUXILIARY JOBS
B–63304EN/02
1. SUBMEMORY INITIALIZATION
298
1
SUBMEMORY INITIALIZATION
To the question, REQUEST =, key in:
REQUEST = CFINT INPUT
To the question;
EXECUTION = OK <, NO OF REGISTERABLE FILES>
EXECUTION =
Key in,
EXECUTION = 1 INPUT
and the submemory can be initialized.
(1)The system parameters, MTF, and setting data on main memory are
registered in the system area.
(2)The FANUC standard data is registered in the system area.
(3)Drawing data and initial screen data are cleared.
(4)The file area is cleared.
When the power is turned on while the SP key is held down, the following
processing is performed to initialize submemory:
(1)The FANUC standard system parameters, MTF, tool data, and setting
data are registered in the system area.
(2)Drawing data and initial screen data are cleared.
(3)The file area is cleared.
Submemory must be initialized when:
(1)Submemory has been replaced
(2)Submemory has been added
(3)The submemory backup battery is replaced while the NCs power is
off.

Leave a Reply

Your email address will not be published. Required fields are marked *