Fanuc Symbol CAPi T Operators Manual

AUXILIARY JOBS
B–63304EN/02
2. CONVERSION OF INPUT UNIT
(MM/INCH)
300
(1)Data to be converted
The object of the conversion is data on the main memory. Transfer the
data stored in submemory to main memory, convert and restore in
sub–memory.
(a) System parameters
Description data separated miri specification from inch
specification in System parameter list.
(b)MTF
Description data separated miri specification from inch
specification in Machine file list.
(c) Tooling information
List of converted data
Drilling tool
1. Drill diameter DD (mm) ´ (inch)
2. Fixing position XS (mm) ´ (inch)
ZS (mm) ´ (inch)
General purpose tool
1. Nose radius RN (mm) ´ (inch)
2. Imaginary tool nose position XN (mm) ´ (inch)
ZN (mm) ´ (inch)
3. Tool nose width WN (mm) ´ (inch)
4. Fixing position XS (mm) ´ (inch)
ZS (mm) ´ (inch)
In the case of milling tool
1. Tool diameter DT (mm) ´ (inch)
2. Cutting diameter DS (mm) ´ (inch)
3. Cutter length LT (mm) ´ (inch)
4. Bite length LE (mm) ´ (inch)
5. Pitch PT (mm) ´ (inch)
6. Installation position XS (mm) ´ (inch)
ZS (mm) ´ (inch)
(d)Material data
List of converted data
In the case of turning condition
1. Center drill Cutting speed (m/min) ´ (feet/min)
Feed amount 1 (mm/rev)´ (inch/rev)
2. Drill Cutting speed (m/min) ´ (feet/min)
Feed amount 1 (mm/rev)´ (inch/rev)
3. Rough machining Cutting speed (m/min) ´ (feet/min)
Feed amount 1 (mm/rev)´ (inch/rev)
Feed amount 2 (mm/rev)´ (inch/rev)
Feed amount 3 (mm/rev)´ (inch/rev)
Cutting depth (mm) ´ (inch)
4. Semifinish Cutting speed (m/min) ´ (feet/min)
Feed amount 1 (mm/rev)´ (inch/rev)

Leave a Reply

Your email address will not be published. Required fields are marked *