Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
310
When the same data like standard surface roughness, for example, is input
in the FAPT execution process, you can preset these data and execute
FAPT, while skipping these preset pages during practical execution stage
of FAPT.
You can skip the following questions.
(a) Question of standard surface roughness
(b)Question in drawing format
(c) Question of home position
(d)Question of index position
(e) Question of machining start position
(f) Question of surface roughness
These pages can be set by system parameter. (To act (a) (b) (c) (d) (e) use
parameter No.9, for (f) use parameter No.10).
For skipping the page, observe the following procedure.
(1)Data setting of system parameter
Set the data for the pictures to be skipped to system parameters No.200
and Nos.205 to 213.
No.200: Drawing format
No.205: Standard surface roughness
Nos.206 to 209: Home position
Nos.210 to 213: Index position
(2)Designation of skip page (System parameter No.0009)
Respective bits of system parameter No.0009 correspond to the pages
to be skipped as follows.
If you want to skip a certain page, set “1” to the corresponding bit. Set
“0” to the corresponding bit, if you don’t want to skip the page.
Be sure to set “0” to the bits which don’t correspond to pages to be
skipped. Details of system parameter No.9.
0 0 0
Question of the index position
Question of the home position
Question of the machining start position
(Caution 2) (Caution 3)
Prompt relating to the Yaxis turret turning
position and machine zero point (Note)
Question of the drawing format
Question of the standard surface roughness
Vacant
(Caution 1)
Vacant
1”: Corresponding page is skipped.
0”: Corresponding page is not skipped.
1.1
SKIP FUNCTION OF
PAGE AND
QUESTION

Leave a Reply

Your email address will not be published. Required fields are marked *