Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
316
(2)Cautions on operation
(a) Calculate the magnification for expansion or contraction so that the
area specified by the cursor is limited within the following range.
When the figure of blank
is long in the lateral direc-
tion;
When the figure of blank
is long in the longitudinal
direction.
A tool path exceeding the above frame is not erased in case of
expansion. Accordingly, the question may overlap a figure as the
case may be.
(b)If the cursor overshoots one end of the CRT when it is shifted, it
appears again from the opposite side.
(c) The coordinate values can be directly specified when the system
asks a question. The cursor shifts to the position corresponding to
the input coordinate values.
(The X coordinate value indicates a diameter value, while the Z
coordinate value is always positive in the right direction.)
(d)If you want to return an expanded or contracted graphic display to
its original size, depress ORIGINAL key.
(e) Since the tool path outside the graphic display area of CRT is also
processed in the expansion mode, it takes a long display time, if a
narrow areas is specified aimlessly. When KILL is depressed,
display operation is stopped.
(f) The cursor shifts 6.4 mm (standard), each time the cursor key is
depressed once. This move amount is changeable by using system
parameter No.0014.
The assignable is a multiplier of 1.6 mm inclusive.

Leave a Reply

Your email address will not be published. Required fields are marked *