Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
318
When [PROC. ON] is displayed during the preparation of NC data, the
NC data output can be stopped every machining process.
An optional data can be entered from the keyboard in the same manner
as in the single step of block. The [PROC. ON] and [SINGLE ON] are
different from each other as specified below.
[PROC. ON] Single step in each process. . . .
System parameter setting is required.
[SINGLE ON] Single step in each NC data block.. .
This key is always effective.
The operation after stop is identical in respective cases.
Parameter setting method
Set the stop position in each process to system parameter No.0049 to
No.0057, No.0310 to No.0314, and No.0410 to No.0414.
0 0 0 0 0
Process start
Just before approach
Just before return relief
When the value is 0 NC data output is not stopped.. . . . . . . . . . . . . . . .
When the value is 1 NC data output is stopped.. . . . . . . . . . . . . . . .
The stop position corresponds to the above setting as follows.
Start of process NC data output is stopped after displaying. . . . . . . . . .
the first data (coordinate system setting G50
block usually) in the process.
Just before approach NC data output is stopped after displaying. . . . .
the first movement from the turret turning
position to the workpiece. A tool number
(T code) and spindle rotation command are
normally output before this block.
Just before return relief NC data output is stopped just before the. . .
tool returns to the turret turning position
after machining ends in the process.
1.4.2
Single Step of Process

Leave a Reply

Your email address will not be published. Required fields are marked *