Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
321
(3)Warnings
WARNING
1 If NC requires a program number (by MTF setting,
No.1080), the program number in the output process is
displayed by the program number + corresponding process
number value. If a change of this number is desired, specify
a new number.
However, this number is not stored. It is, therefore,
necessary for correcting and outputting the same process
again to input a new number each time. If this function is
employed when NC data have not been prepared at all in
all processes, the program number always remains
undefined. Specify program No. each time in such a case.
2 Data in the preparation process being with the turret turning
position, and returns to the turning position.
3 If the subprogram format is used together, the subprogram
part only is output.
4 When using this function, must define the machining start
point.

Leave a Reply

Your email address will not be published. Required fields are marked *