Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
328
Example:
If the axes are decomposed in the order of X axis and Z axis in one axis
at a time control when the X axis only moves for return relief, the X
axis does not move in the 2nd motion, but it moves in the 1st motion
only.
MTF 2033
When MTF 1002 = 0
Tool
changing
point
If MTF 2033 and 2034 are set as shown
in example below:
G28.00; is output
MTF 2033
When MTF 1002 = 1
Tool
changing
point
MTF 2034
MTF
parameter
No.
Setting value
4102 DD01 CC01 0004
2033
G28 U0 W0 EOB
4102 DD01 CC01 0004
2034
G28 U0 W0 EOB
When the axes were decomposed in the order of X axis and Z axis in one
axis at a time, the G code and setting values are output as follows.
G28 U0;
G28 W0;
When the axes are decomposed in the order of Z axis and X axis in one
axis at a time, the G code and setting values are output as follows.
G28 W0;
G28 U0;

Leave a Reply

Your email address will not be published. Required fields are marked *