Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
329
WARNING
When a system parameter value or an MTF parameter
value is modified, check the prepared NC data. Machining
with incorrect NC data may result in the tool colliding with the
workpiece and/or machine, or forced machining occurring,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
The NC data, which are fitted for operation utilizing the direct input of
tool offset value, can be output.
In this case, the coordinates of home position must be set. If this is not
set, the block for positioning to the index position will not be output.
(1)NC Tape format
The following NC data for direct input of tool offset value is available,
if “00000101” is set to MTF 1060 and settings of MTF 2000s is changed.
However, if reference point return is not required, the data correction for
MTF 2000 and 2001 is not necessary.
O1234
G28U0 }Reference point return
G28W0
G50S2000 Coordinate system setting is not output.
G00T0100 }Turret
G00X200Z200T010M08 }Approach, Tool offset start, Coolant on
.
.
.
.
G00X200Z200T0100M09 }Return, relief, Tool offset cancel,
Coolant off
G28U0W0 }Reference point return
M30
1.9
UTILIZATION OF
DIRECT INPUT OF
TOOL OFFSET
VALUE

Leave a Reply

Your email address will not be published. Required fields are marked *