Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
330
(2)Setting of parameters (example)
Setting of MTF No.2000, 2001, 2016, 2018 and 2019 is changed as
follows.
Number Set value
2000
0104, 0004, 0603, 0004, 4102, 1107, 0004, 4107, 0107, 0004
(“EOR EOB O EOB G28 U0 EOB G28 W0 EOB is output at
reader part of NC data.)
2001
0205, 0004, 4102, 1107, 0107, 0004, 0505, 0004, 0104, 0004
(“M05 EOB G28 U0 W0 EOB M30 EOB EOR EOB is output at the
trailer part of NC data.)
2016
4402, 0303, 0004, 0002, 0103, 0004, 0000, 0000
(“G50 s EOB G00 T EOB is output at the start of process. In
standard setting, G50X Z is output. In this setting, the
independent G50 block is output at the start of a process which
does not employ any constant surface speed control.
2018
5202, 5002, 1101, 0001, 0103, 0305, 0004, 0000, 0000, 0000
(“G90 G00 X Z T0101 M08 EOB is output at the time of
Approach.)
2019
5202, 5002, 1101, 0001, 0003, 0405, 0004, 0000, 0000, 0000
(“G90 G00 X Z T0100 M09 EOB is output at return relief.)
(3)Warnings
WARNING
1 For MTF No.2000 and 2001, maximum 10 parameters only
can be set, respectively. In case of a setting sample in (2),
neither feed at the start and end of a program not T code
(MTF No.1106) at the end of the program is output, although
these feed and code are output in standard setting.
2 If the setting is changed as the following example, the
approach and return relief should be specified
simultaneous two axes. And the system parameter
No.0107 to 0115 should be set so as to output tool offset
cancel.
#7
0107 to 0115
#6 #5 #4
0
#3
0
#2
1
#1 #0
Bit 2 Tool offset cancel is output.
Bit 3, 4 Approach and return relief should be specified simultaneous 2 axes.
System parameter

Leave a Reply

Your email address will not be published. Required fields are marked *