Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
333
The following table shows the same example.
AC AN AS XS ZS
T01 85 –80 180 +
T02 –85 80 180 + +
(4)Question about cutting start position
The cutting start position is automatically calculated from the index
position, XS and ZS values are displayed. Since the X value at the
index position is undefined, the X value at the cutting start position
also remains undefined. Specify the cutting start position X in the first
process without fail. The cutting start position X in the second and
higher processes are kept undefined. Thus, the tool is replaced by
pulling the Z axis only to the index position without returning the tool
to the index position.
(5)Inversion of X coordinate signs
The system asks whether the X coordinate signs are inverted or not in
the same way as in setting the cutting start position. Input 1 for the tool
which cuts on the X side. In the example shown in the above figure,
T02 corresponds to drawing format 1 or 2, while T01 corresponds to
drawing format 3 or 4.
(6)Explanation by definite example
The execution method will be described definitely, referring to an
example.

Leave a Reply

Your email address will not be published. Required fields are marked *