Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
341
Enter 18 “INPUT” on the SYSTEM DATA SETTING &
OUTPUT/INPUT screen. Then, the screen for setting initial screen
display data appears. On this screen, set screen display data using
appropriate G codes.
Up to 432 lines can be set. If an attempt is made to set data beyond 432
lines, an alarm is issued.
(1)Coordinates
Coordinates are represented in two ways: Dotbased representation,
and characterbased representation.
Dot–based Character–based
When characters are displayed, they are input at coordinates
corresponding to the character positions on the 14inch CRT (screen)
(27 lines by 74 columns) (figure above). Characters can be
displayed anywhere within the screen area (24 lines by 64 columns)
except in the right NC display area and soft key display area at the
bottom. Thus, characters can be displayed at the following
coordinates:
First line: Character addresses 0 to 63
Second line: Character addresses 74 to 137
Third line: Character addresses 148 to 211
Fourth line: Character addresses 222 to 285
Fifth line: Character addresses 296 to 359
Sixth line: Character addresses 370 to 433
Seventh line: Character addresses 444 to 507
Eighth line: Character addresses 518 to 581
Ninth line: Character addresses 592 to 655
10th line: Character addresses 666 to 729
11th line: Character addresses 740 to 803
12th line: Character addresses 814 to 877
13th line: Character addresses 888 to 951
14th line: Character addresses 962 to 1025
15th line: Character addresses 1036 to 1099
16th line: Character addresses 1110 to 1173
17th line: Character addresses 1184 to 1247
18th line: Character addresses 1258 to 1321
19th line: Character addresses 1332 to 1395
20th line: Character addresses 1406 to 1469
21st line: Character addresses 1480 to 1543
1.12.2
Setting Initial Screen
Display Data

Leave a Reply

Your email address will not be published. Required fields are marked *