Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
349
Parameter
No
Format Description
16T/TT
initial value
15TFB/TTFB
setting
1367 Real
number
High–speed peck drilling cycle (machining type: 2), side 87. 83.1
1368 Real
number
Tapping cycle, front 84. 84.
1369 Real
number
Tapping cycle, side 88. 84.
1370 Real
number
Reverse tapping cycle, front 84. 84.1
1371 Real
number
Reverse tapping cycle, side 88. 84.1
1372 Real
number
Rigid tapping cycle, front 84. 84.2
1373 Real
number
Rigid tapping cycle, side 88. 84.2
1374 Real
number
Rigid reverse tapping cycle, front 84. 84.3
1375 Real
number
Rigid reverse tapping cycle, side 88. 84.3
1380 Real
number
Start/cancellation of cylindrical interpolation 107. 7.1
1381 Real
number
Start of polar coordinate interpolation 112. 12.1
1382 Real
number
Cancellation of polar coordinate interpolation 113. 13.1
1390 Integer Output format of canned cycle R code (*3) 1 0
1391 Single
character
Canned cycle repetitive code K L
*1 If MTF No.1260 is 94, the conventional system outputs G98,
assuming G code system B or C. In the new system, MTF No.1262
is newly provided so that an arbitrary value can be output as the initial
point return G code for G code system B/C. Normally, set 98 in MTF
No.1262.
*2 MTF No.1321 is referred at the time of rigid tapping cycle output.
However, it is not required when output is performed in the 15T
format. So, be sure to set MTF No.1321 to –1.
Note that MTF No.1321 is referred for 5700 series of 16T CAP II.
*3 As the canned cycle reference position (R code), an absolute value is
output if parameter No.1390 is set to 0; an incremental value is output
if the parameter is set to 1.

Leave a Reply

Your email address will not be published. Required fields are marked *