Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. VARIOUS FUNCTIONS OF
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
353
This function is used to define the tool change method in NC data so that
the corresponding tool to be used in the next process will be called. This
function is applied to all machining processes except sub cycles.
This function is an optional function.
(1)Programming
Programming is performed in the same way as for normal
programming.
(2)System parameter
Parameter
No.
Format
Initial
value
Description
706 Specificatio
n of 0 or 1
00000000 Bit 5 = 0: The next tool is not called
for turret 1.
1: The next tool is called for
turret 1.
Bit 6 = 0: The next tool is not called
for turret 2.
1: The next tool is called for
turret 2.
(3)MTF
1) MTF1xxx
The following parameters have been added:
No. Format
Initial
value
Description
1355 Integer 6 Tool calling M code value
1400 Two–charac
ters
BB Next tool calling command address
(the same two characters are
specified)
2) MTF function table
The following function table has been added:
2066 (setting the next tool calling block)
1203, 0004, 0A05, 0004, 0103, 0004, 1303, 0004, 0000, 0000
B;M06;T;B;
3) Function code
The following function codes have been added:
Higher three
digits
Detailed
classification
Lowest digit
Major
classification
Function
1 2 0 3 Outputs the address specified with MTF1400.
(Tool number used in the first block)
1 3 0 3 Outputs the address specified with MTF1400.
(Tool number used in the next process)
0 A 0 5 Outputs the M code (M06) specified with
MTF1355.
(Tool calling)
1.14
FUNCTION FOR
PREPARING THE
NEXT TOOL

Leave a Reply

Your email address will not be published. Required fields are marked *