Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
2. CAUTIONS FOR USING
Symbolic FAPT
372
(3)Machining start point and end point coincide
No machining is possible, if the start point of part figure coincides with
the end point and these points are located on a blank profile (blank
figure).
Z axis judges it as the profile figure of a blank.
In case of the above figure, machining becomes possible, if a dummy
figure element of about 0.01 mm in length is inserted.

Leave a Reply

Your email address will not be published. Required fields are marked *