Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. CAUTIONS FOR USING
Symbolic FAPT
VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
373
(4)Difference of tool paths according to dividing direction of area
When the end face or outer diameter is continuously machined in the
medium finish cutting or finish cutting process, the cutting method
differs according to the specification of the dividing directions of the
cutting area. (Refer to the following finish cutting as an example.)
NOTE
Fi: Feedrate by the specification of surface roughness
Fj: Feedrate by the specification of standard surface
roughness
(5)Concept of area in semifinish and finish cutting
In the semifinish and finish, cutting is made along the part figure
only, while neglecting the blank figure. The profile in the arrow
direction specified when dividing the machining area is regarded as a
part of the part profile.

Leave a Reply

Your email address will not be published. Required fields are marked *