Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
2. CAUTIONS FOR USING
Symbolic FAPT
386
(20) If NC data for end face roughing is not output normally
If the cutting area for end face machining is divided as shown in Fig.
2.5 (ad), a cutting area that temporarily has two closed areas
(portions A and B) is created internally as shown in Fig. 2.5 (ae)
when compensation related to the finishing allowance or nose R is
performed. Then, portion B is removed, and only portion A is left
as the cutting area. As a result, NC data that cuts only portion A is
output.
In this case, change the dividing direction as shown in Fig. 2.5 (af).
Changing the dividing direction creates an appropriate cutting area
rather than the one shown in Fig. 2.5 (ae).
Fig. 2.5 (ad) Fig. 2.5 (ae) Fig. 2.5 (af)
Blank figure
Part
Portion A
Portion B

Leave a Reply

Your email address will not be published. Required fields are marked *