Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
2. CAUTIONS FOR USING
Symbolic FAPT
392
Refer to item 1.11.3.
If the blank figure at the entrance of the groove is not parallel to the X axis
or Z axis in case of grooving, give care to the following note.
WARNING
In the case of grooving tool, interruption is checked at virtual
tool position by the designated nose R.
If a bad tool path is output by this process, designate the
other side of nose R at virtual tool position.
The groove bottom must be flat.
The flat portion must be equal to or larger than the flat portion of the tool
nose.
2.7.2
Interference Check
2.7.3
Blank Figure in
Grooving Area
2.7.4
Groove Bottom Figure

Leave a Reply

Your email address will not be published. Required fields are marked *