Fanuc Symbol CAPi T Operators Manual

VARIOUS FUNCTIONS AND
PRECAUTIONS OF Symbolic FAPT
B–63304EN/02
2. CAUTIONS FOR USING
Symbolic FAPT
402
In the Symbolic FAPT, the left side of a blank is chucked as a
precondition.
However, if you set Z axis to execute the counter rotational output by
machine tool file parameters No.1001, NC data output only can be
executed with Z axis (minus).
WARNING
Before starting machining based on the prepared NC data,
thoroughly check the contents of the NC data. Machining
with incorrect NC data may result in the tool colliding with the
workpiece and/or machine, or forced machining occurring,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
(1)Function to skip XS and ZS questions when the turret turning position
is fixed (inputtable), the cutting start position is inputtable, and also
tool lengths XS, ZS are unknown.
#7
0104
#6 #5 #4 #3 #2 #1 #0
Bit 0 0 : Non skip
1 : Skip
NC data to return to the start point at return relief is prepared by
designating “1”. When “1” is specified;
1) The start point cannot be kept undefined.
2) The turret turning position is determined XS, ZS, and start point, if it
is undefined. If both XS and ZS are also undefined, the turret turning
position is obtained, assuming that XS and ZS are zero.
2.12
OTHER
PRECAUTIONS
2.12.1
Chucking Position
2.12.2
Cutting Start Position
and Others
System parameter

Leave a Reply

Your email address will not be published. Required fields are marked *