Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
1. PART FIGURE DEFINITION
(MENU 2)
412
The graphic data input screen is as shown below except Face Milling and
Side Milling.
ESCAPE: Returns the display to the program menu screen. (The
input data becomes valid.)
BACK PAGE: Returns the display to C axis machining menu screen.
When this key is depressed in the cursor of data setting,
the already input data becomes invalid. (It becomes valid
when “CHECK” is pressed, however.)
CHECK ALL: Draws the figure according to the input data. (All
C–axis–related figures having the figure numbers that
are lower than the one currently being defined are drawn.)
CHECK: Draws the figure according to the input data. (Only
patterns defined here are drawn.)
CURSOR °: Moves the cursor forward and backward.
CURSOR ±:
NEXT PAGE: C axis machining menu screen proceeds.
(1)Insert screen for end face hole machining
POSITION (XAXIS) DX = Hole position (X coordinate value).
DEPTH DT = Depth of a hole. . . . . . . . . . . . .
HOLE DIAMETER WT = Diameter of a hole. . .
CENTER DRILL CG = 1 to perform the center drilling; 0 not. . . . .
to perform the center drilling.

Leave a Reply

Your email address will not be published. Required fields are marked *