Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
1. PART FIGURE DEFINITION
(MENU 2)
414
(2)End surface grooving (Caxis rotation direction) input screen
POSITION (XAXIS) DX = Groove position (X coordinate.
value)
DEPTH DT = Depth of a groove. . . . . . . . . . . . .
GROOVING WIDTH WT = Diameter of a groove. .
GROOVING ANGLE AG = Angle of a groove. .
INTERVAL AB = When plural grooves are drilled, set. . . . . . . . . .
interval of groove position to be
fixed or variable. (0: FIXED 1:
VARIABLE)
QUANTITY AC = Number of grooves . . . . . . . . .
(in case of fixed interval, up to 100
holes can be specified.)
Fro 5700 series of 16T CAP II, up
to 16 holes can be specified along
fixed interval.
INITIAL ANGLE A1 = Position of groove (Cutting start. . . . .
angle. Angle of the first groove in
case of plural grooves)
ANGLE A2 = Cutting start angle of the 2nd groove. . . . . . . . . . . . .
(in case of variable interval)
A3 = Cutting start angle of the 3rd groove
(in case of variable interval)
A4 = Cutting start angle of the 4th groove
(in case of variable interval)
A5 = Cutting start angle of the 5th groove
(in case of variable interval)
FINAL ANGLE AE = Cutting start angle of the last groove. . . . . .
when plural grooves are drilled.
If more than one groove is specified, all grooves will have the same length
(value specified at AG).

Leave a Reply

Your email address will not be published. Required fields are marked *