Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. PART FIGURE DEFINITION
(MENU 2)
C–AXIS FAPT FUNCTION
415
NOTE
If “VARIABLE” is selected in response to the “INTERVAL”
prompt, it is necessary to specify that the angles A1 to AE
rotate in the same direction. If this requirement is not
satisfied, a Necessary data missing error is detected.
(3)End surface grooving (X direction) input screen
GROOVING LENGTH XG = length of the groove. . .
The other items are the same as those for end surface grooving (C–axis
rotation direction).
(4)Insert screen for side hole machining
POSITION (ZAXIS) LZ = Hole position . . . .
(Z coordinate value)
Other questions are the same as for the end face hole.

Leave a Reply

Your email address will not be published. Required fields are marked *