Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
1. PART FIGURE DEFINITION
(MENU 2)
420
4) List mode displays
¿
(c) Notes
NOTE
When defining multiple single stroke figure, the following
limitations are applicable:
(i) It is not possible to change element directions (CP) for
single figures.
(ii) Figures with level differences cannot be defined.
(per one definition)
(iii) It is not possible to program front and rear
simultaneously.
Due to the above, from among the prompts for the starting
point element for the second and subsequent figures, the
following prompts are not mode:
(i) Element direction (CP)
(ii) Z axis value for starting point
(d)Creating NC text
1) NC text is created for machining figures (defined in menu 2) in the
order in which they were defined.
2) When machining of one figure has been completed, the tool will
move away before heading toward the starting point for the next
figure (at fast feed speed). The direction of this initial movement
is as follows:
(i) When cutting elements to the left or right, the tool moves in the
X axis direction.
(ii)When cutting elements, the tool moves in the Z axis direction.

Leave a Reply

Your email address will not be published. Required fields are marked *