Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
1. PART FIGURE DEFINITION
(MENU 2)
424
b) When the drawing format is 2 or 4.
Expansion diagram
NOTE
2 Only one cylindrical groove figure, which is drawn as a
single stroke figure, can be defined; two or more cylindrical
groove figures cannot be defined. However, specifying a C
value of 360 or more (degrees) enables a figure with one or
more turns to be defined.
3 The following are not permitted for cylindrical groove figure
definition:
(1)Incremental input of the C value
(2)Specification of TL (tangent to the last figure) or TN
(tangent to the next figure)
(3)Specification of the radius value for a circular element
(4)Definition in list mode

Leave a Reply

Your email address will not be published. Required fields are marked *