Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
2. MACHINING DEFINITION
(MENU 4)
432
(Drill)
TOOL TYPE TP; Drill (M)
TOOL MATERIAL MT;. . . . . . . .
TOOL DIAMETER DT =. . . . . . . .
CUT LENGTH LT = . . . . . . . . . . .
NOSE ANGLE AT =. . . . . . . . . . .
(Tap)
TOOL TYPE TP; Tap (M)
TOOL MATERIAL MT;
TOOL DIAMETER DT =. . . . . . . .
CUT LENGTH LT = . . . . . . . . . . .
PECK LENGTH LE =. . . . . . . . . .
PITCH PT =. . . . . . . . . . . . . . . . . .
(End mill)
TOOL TYPE TP; End mill (M)
TOOL MATERIAL MT;
TOOL DIAMETER DT =. . . . . . . .
CUT WIDTH DS =. . . . . . . . . . . . .
CUT LENGTH LT = . . . . . . . . . . .
CUT COUNT NT =. . . . . . . . . . . .
NOTE
3 The setting of tool figure data can be disabled, and the data
can be displayed only. To do this, change the following
parameter setting:
No.702: 0 0 0 0 1 0 0 0
Specifies whether tool figure data can be set in m
chining definition.
= 0: Tool figure data cannot be set. (Only the display is enabled.)
= 1: Tool figure data can be set.
Prompts on data of setting (Common to all tool types)
SETTING DIRECTION CP = (0: Side machining, 1: End. . . . .
machining)
SETTING POSITION XS = . . . . . .
ZS =
ROTATE DIRECTION TR = (0: Forwards, 1: Backwards) . . . . . .
HOLDER NO. HL = (Note 4). . . . . . . . . . . .
NOTE
4 The holer number (HL) prompt is displayed if the optional
animation drawing function is available.
5 When a tool registered in the tool data is used, the set data
is registered as tooling information when the user proceeds
to the next screen by pressing the NEXT PAGE soft key.

Leave a Reply

Your email address will not be published. Required fields are marked *