Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. MACHINING DEFINITION
(MENU 4)
C–AXIS FAPT FUNCTION
433
WARNING
When NC data are created, the interference check or offset
calculation is performed for the tool data according to the
tool figure. If tool data is not input correctly, correct NC data
cannot be output.
When all tool data are input, the screen asks the machining start position.
MACHINING START POSITION
X coordinate values DXO = . . . . .
Z coordinate values ZO =. . . . . .
WARNING
The cutting conditions are automatically set according to the
selected machining type. Check the set conditions. If the
conditions are incorrect, the tool may collide with the
workpiece and/or machine, or forced machining may occur,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
(1)Center drilling
DEPTH OF CUT D = Depth of cut (mm or inch). . . . .
CLEARANCE C1 = Clearance (mm or inch). . . . . . .
RPM N = Tool rotation speed (rpm). . . . . . . . . . . . . . .
FEED RATE FT = Feed amount per tool rotation . . . . . . . . .
(mm/rev)
2.1.3
Machining Start
Position
2.1.4
Cutting Conditions

Leave a Reply

Your email address will not be published. Required fields are marked *