Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. MACHINING DEFINITION
(MENU 4)
C–AXIS FAPT FUNCTION
435
TYPE 3
CLEARANCE C1 = Clearance 1 (mm or inch). . . . . . .
C2 = Clearance 2 (mm or inch)
C3 = Clearance 3 (mm or inch)
DEPTH OF CUT D1 = Depth of cut (mm or inch). . . . .
RPM N = Tool rotation speed (rpm). . . . . . . . . . . . . . .
FEED RATE FT = Feed amount per tool rotation . . . . . . . .
(mm/rev)
TYPE 4 (G85/G89 boring cycle)
CLEARANCE C1 = J³ The initial value is set to the. . . . .
value of system parameter No.
332 (clearance 1 in drilling 1).
C2 = J³ The initial value is set to the
value of system parameter No.
333 (clearance 2 in drilling 2).
DWELL ON/OFF DW = J³ When dwell is set to on, the. .
dwell time set in system
parameter No. 320 is output
during NC data preparation.
RPM N = J³ V*1000/DT*PAI. . . . . . . . . . . . .
(V = cutting speed value set in
the material data, DT = tool
diameter value set in the tool
data)
FEED RATE FT = J³ The initial value is set to the. . . . . .
value of feed amount/FT in the
material data.

Leave a Reply

Your email address will not be published. Required fields are marked *