Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
3. ANIMATED SIMULATION
FUNCTION (MENU 6)
448
When the following two conditions are filled, it is possible to display
C–axis FAPT screen in place of conventional animated screen.
The screen where an XZ side view and an XC front view are located
at the left and the right respectively is called the Caxis FAPT animation
screen.
1. The option of Caxis FAPT is provided.
2. The part figure data for Caxis machining is defined in Part figure
definition screen of the menu 2.
When the Caxis FAPT option is not provided or when no Caxis part
figure is defined even if the option is provided, the animation drawing of
only XZ side view appears.
Even when the Caxis FAPT animation drawing conditions are satisfied,
conventional animation screen can be selected by the setting on the
animation parameter screen.
(1)Screen
1) X–Z side view
The workpiece is painted out for drawing as usual.
The machined contour part by the Caxis is not drawn.
2) X–C front view
The final contour including Caxis machining part is drawn,
similarly on the part figure definition screen in the menu 2.
The workpiece is also painted out.
Fig. 3.2.1 (a)
3.2
SPECIFICATION
3.2.1
C–axis FAPT Animated
Screen

Leave a Reply

Your email address will not be published. Required fields are marked *