Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. ANIMATED SIMULATION
FUNCTION (MENU 6)
C–AXIS FAPT FUNCTION
449
(2)Animated simulation
a) Turning process
1) X–Z side view
As usual, the tool and the tool path are drawn and the manner
how to the tool cut the painted out workpiece is displayed.
2) X–C front view
Simulation of turning process is not done in the XC front view.
b) C–axis machining
1) X–Z side view
The tool and the tool path are drawn in the same way as the
turning process. However, the machined part is not cut.
2) X–C front view
The Caxis machining is drawn by the tool moving on the
workpiece contour. The outline of the tool is left over in the
machined part.
(Paint drawing is not done for the workpiece. A front view is
not rotated.)
The simulation of the machining of part A in Fig. 3.2.1 (a) is
shown in the Fig. 3.2.1 (c).
Fig. 3.2.1 (b)
Fig. 3.2.1 (c)

Leave a Reply

Your email address will not be published. Required fields are marked *