Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. ANIMATED SIMULATION
FUNCTION (MENU 6)
C–AXIS FAPT FUNCTION
451
(3)Tool figure for milling machining
The following four patterns are prepared as the shape pattern of the
rotation tool for milling machining.
1) Drawing of a tool holder is done only in XZ side view.
2) The center drill and the drill tool are drawn by pattern 2 and pattern
4.
Tap and end mill tool are drawn by pattern 1 and pattern 3.
3) The painted out length of the tool tip on the XZ side view is LT
value set to the tooling data. (In case of tapping tool, the length is
LT + LE.)
The next screen is displayed when the soft key “PARAMETER” is pushed
in Caxis FAPT animated screen.
The question Drawing type C = is displayed, when the condition in
C–axis FAPT animated screen explained in 3.2.1 is filled.
C = 1: Caxis FAPT animated screen
C = 0: Animated screen only by XZ side view
3.2.2
Parameter Screen for
Animated Simulation

Leave a Reply

Your email address will not be published. Required fields are marked *