Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. MATERIAL AND TOOL DATAC–AXIS FAPT FUNCTION
453
(1)Cutting condition with high speed tool in milling machining
Feed amount (*)
Division
Cutting speed
V
FR
(Diameter
direction)
FT
(Axis
direction)
Center drill f f
Drill f f
Tap f
End mill f f f
(*) Set the feed amount per one blade in case of end mill.
(2)Cutting condition with the carbide tool in milling machining.
It is the same as (1).
NOTE
The increment system of the cutting speed is m/min or
feet/min.
The increment system of the feed rate is mm/rev or inch/rev.
The increment system of the infeed amount is mm or inch.
Refer to material data in chapter VI 1. for methods to set and display the
data.
4.1
MATERIAL DATA

Leave a Reply

Your email address will not be published. Required fields are marked *