Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. MATERIAL AND TOOL DATAC–AXIS FAPT FUNCTION
455
It is possible to input and output the tool data and collate it in the
conventional way. The input and output format of the tool data for milling
machining is as follows.
CINOOOP ; Tool ID number (ID)
CINOOOP ; Tool type (TP)
CINOOOP ; Cutting diameter (DS)
CINOOOP ; Tool length (LT)
CINOOOP ; Tool tip angle (AT)
CINOOOP ; Tool diameter (DT)
CINOOOP ; Peck length (LE)
CINOOOP ; Pitch (PT)
CINOOOP ; Setting position (Y–axis) (YS)
CINOOOP ; Setting position (Xaxis) (XS)
CINOOOP ; Setting position (Zaxis) (ZS)
CINOOOP ; No. of blades (NT)
CINOOOP ; Tool material (MT)
CINOOOP;
CINOOOP;
CINOOOP;
CINOOOP;
CINOOOP;
CINOOOP;
CINOOOP ; Tool imformation (FLAG)
CINOOOP ; Holder No. (HL)
CINOOOP ; Tool information 2 (FLAG 2)
Meaning of tool information 2 (FLAG 2)
#7 #6 #5 #4 #3 #2 #1 #0
Bit 0 Rotation direction (TR)
0 : Normal rotation
1 : Reverse rotation
Bit 1 Installation direction (CP)
0 : For side machining
1 : For end face machining
4.2.2
Input and Output of the
Tool Data and Collation

Leave a Reply

Your email address will not be published. Required fields are marked *