Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
4. MATERIAL AND TOOL DATA
456
The display method of the tooling information list screens is as usual. The
screen moves to the tooling information setting screen when the soft key
DATA SETTING is pushed on this screen. The screens of four kinds
are prepared by the tool type.
TOOL OFFSET NO. TM =. . . . . . .
TOOL ID NO. ID = (Note 1). . . . . . . . . . . . .
NOTE
The tool ID number (ID) to be input must have been
registered in tool data. If a number not registered in tool
data is input, a message This ID is not registered in tool
data.” is displayed. The registered ID is deleted from the
tooling information if keyed in as “DEL” “INPUT”.
When the tool ID number (ID) is input, the tool registered in tool data is
tooled and the data of the tool configuration and that of setting are set.
Display of tool figure data (The tool type (TP) and tool material (MT) are
displayed only; they cannot be changed.)
(Center Drill)
TOOL TYPE TP; Center drill (M)
TOOL MATERIAL MT;
TOOL DIAMETER DT =. . . . . .
CUT WIDTH DS =. . . . . . . . . . .
CUT LENGTH LT = . . . . . . . . .
NOSE ANGLE AT =. . . . . . . . .
(Drill)
TOOL TYPE TP; Drill (M)
TOOL MATERIAL MT;
TOOL DIAMETER DT =. . . . . .
CUT LENGTH LT = . . . . . . . . .
NOSE ANGLE AT =. . . . . . . . .
4.2.3
Displaying and Setting
of Tooling Informations

Leave a Reply

Your email address will not be published. Required fields are marked *