Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
5. MTF
476
(3)MTF Setting
1) Define the value of the M code for specifying the rigid tapping
mode in MTF No.1350.
2) MTF function tables 2207 and 2208 are used for both general
tapping and rigid tapping.
FANUC standard MTF
1350=29 ...
2207=5802,6602,6302,1101,0001,AA01, 0903,1505, 0203,0005
G98 G98 G84 X Z C R MXX S Mxx
G99 G88
2208=0503,0B03, 0004, 0000
FK ;
CAUTION
When rigid tapping is to be performed, set an F code after
the S code setting in MTF function table Nos.2207 and
2208. If the F code is specified before the S code, the F
code and its value are not output.
New function code
Three high-order
digits
One low-order
digit
Function Preparation
1 5 0 5
Outputs M code
that specifies rigid
tapping.
M code set in MTF
No.1350

Leave a Reply

Your email address will not be published. Required fields are marked *