Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. START OF Symbolic
FAPT PROGRAMMING
PROGRAMMING AND
OPERATION BY Symbolic FAPT
31
[DATA SET] This key is used for input/output and setting of. . . . .
system parameter, machine tool file (MTF),
setting data, material file and tooling data. For
storage of material files and tooling files,the
submemory, the memory cassette or paper tape is
used.
[AUXILIARY] This key is used to initialize sub memory. . . .
FAPT execution
Press the FAPT execution on the initial screen to allow the FAPT
execution procedures menu to be displayed, By pressing the Software key
“Execution”, programming is initiated according to the procedures.
Correction can be easily made by directly selecting any menu on
correcting programs. For example, press the Software key “2” for
selecting input of final parts figure. Press the “5” for creating the NC data.
However, it is not possible to execute programming in the reverse order,
namely from larger memory number to smaller one.
Press the “End” when the above screen is being displayed to return to the
initial screen.

Leave a Reply

Your email address will not be published. Required fields are marked *