Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
7. IN–FEED MACHINING IN C–AXIS
FACE MILLING PROCESS
492
A figure can be defined in the same way as a face milling defined in (7)
of Section 1.3.2 of this part, except for the following restrictions:
(1)If multiple face millings are defined in a single definition, this function
is not supported.
(2)If cutting on an entity is defined, this function is not supported.
7.1
FIGURE DEFINITION

Leave a Reply

Your email address will not be published. Required fields are marked *