Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
7. IN–FEED MACHINING IN C–AXIS
FACE MILLING PROCESS
494
When defining data other than the above, there is no difference
from the conventional definition.
However, note the following points when defining data because they
are not checked upon the creation of an NC format.
CAUTION
1 When cutting a face milling from the outside diameter,
setting too great a cutting allowance results in an excess air
cut.
2 When cutting a pocketed face milling from the inner surface,
setting too great a cutting allowance may result in excessive
cutting of a parts figure.
Automatic process determination
When a face milling is defined using the automatic process
determination function, method 2 without infeed machining is set.
Therefore, to use this function, modification is required on the cutting
condition screen.

Leave a Reply

Your email address will not be published. Required fields are marked *