Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
7. IN–FEED MACHINING IN C–AXIS
FACE MILLING PROCESS
496
(1)Roughing
(a) Tool path viewed from an end face
Operation is as follows:
Face milling parts
figure
W1
(Cutting width)
TX+DT/2
(Finishing allowance along the X axis
direction + tool diameter/2)
1) Performs the operation that is set using approach. . . . . .
(The above figure shows an example of normal direction
approach.)
2) Performs the first cutting. . . . . . . . . . . . . . . . . . . . . . . . .
At this time, if the tool path is drawn outside a blank, air cut
results.
3) Cuts the figure by the specified cutting width (W1). . . .
4) Cuts the figure with the finishing allowance (TX) left uncut.
. . . . . . . . . . . . .
5) Performs the escape operation set using the escape method.
. . . . . . . . . . . . .
(The above figure shows an example of normal direction
escape.)
7.5
TOOL PATH
DRAWING

Leave a Reply

Your email address will not be published. Required fields are marked *