Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
7. INFEED MACHINING IN C–AXIS
FACE MILLING PROCESS
C–AXIS FAPT FUNCTION
501
0001(C–FACE) ;
(C–FACE MILLING) ;
N0001G28H0. ;
G50X400.Z100.C0. ;
GOTO01 ;
G97S1000 ;
X283.551 ;
Z12. ;
C44.857 ;
G112 ; ² Polar coordinate system interpolation
start block (MTF No.2214)
G1Z–4.5F4000. ; ² Rapid traverse and cutting feed move
command (MTF No.2017)
X269.373C7.053 ; ² (1)
G2X296.31C–6.348R9.5 ; ² (2) Arc interpolation move command
(MTF No.2021)
X269.373C7.053R9.5 ; ² (3)
G1X258.031C12.696 ; ² (4)
G2X307.652C–11.991R17.5 ; ² (5)
X258.031C12.696R17.5 ; ² (6)
G1X246.69C18.339 ;² (7)
G2X318.994C–17.634R25.5 ; ² (8)
X246.69C18.339R25.5 ; ² (9)
G1X235.348C23.982 ; ² (10)
G2X330.336C–23.276R33.5 ; ² (11)
X235.348C23.982R33.5 ; ² (12)
G1X224.006C29.624 ; ² (13)
G2X341.678C–28.919R41.5 ; ² (14)
X224.006C29.624R41.5 ; ² (15)
G1X238.183C22.571 ; ² (16)
Z12. ;
G113 ; ² Polar coordinate system interpolation
cancel block (MTF No.2215)
G0Z100. ;
X400. ;
TO100 ;
M1 ;
M5 ;
M30 ;
%
NOTE
1 When a pocket is bored from an inner surface contour,
caution is required to avoid specifying too large a cutting
allowance for the pocket, the parts figure may be overcut.
2 An alarm may by issued if the defined pocket figure is
complicated and cannot be cut using the specified tool
diameter.

Leave a Reply

Your email address will not be published. Required fields are marked *