Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
8. CAXIS FAPT FUNCTION B
504
(1)Specifying end face holes along a circle with arbitrary center position.
In addition to the end face hole machining function of the C–AXIS
FAPT FUNCTION, end face holes along a circle with arbitrary center
position can be specified in the following manner.
Select FACE HOLE in the CAXIS FIGURE window of the Menu
No.2.
In the Face Hole definition (CAXIS FIGURE 1) window,additional
new parameter, CIRCLE CENTER CD=, appears. If “1”(Specify
arbitrary center position) is selected for this parameter,following
parameters appear subsequently so that arbitrary center position can
be specified for the circle along which holes are placed.
C.CENTER (X–AXIS) CDX=. . . . . . . . . . .
C.CENTER (C–AXIS) CC=. . . . . . . . . . .
PLANE (Z–AXIS) PZ=. . . . . . . . . . . . . . .
NOTE
1 To specify the diameter of the circle with arbitrary center
position, enter the diameter value in the parameter
POSITION (X–axis)...DX=“.
2 Specify the CAXIS value of the center of the circle in length
(of radius designation), not in angle.Specify the X–axis
value in diameter designation.
Specify with the
parameter “POSITION
(X–axis)...DX=“.
Center (CDX,CC)
8.2
PROGRAMMING
8.2.1
Part Figure Definition

Leave a Reply

Your email address will not be published. Required fields are marked *