Fanuc Symbol CAPi T Operators Manual

C–AXIS FAPT FUNCTION
B–63304EN/02
8. CAXIS FAPT FUNCTION B
506
Following parameters, related to the setting of the tool, are common
for both CAXIS REAMING tool and CAXIS BORING tool.
SETTING DIRECTION CP= () 0:SIDE 1:END) . . . .
SETTING OPTION XS=. . . . . . . .
ZS=
ROTATE DIRECTION TR= (0:NOMAL 1:REVERS). . . . .
HOLDER NO. HL=. . . . . . . . . . . .
MACHINING START POSITION:
DX0=
Z0=
Tool data definition method for other type of tools is the same as that
of CAXIS FAPT FUNCTION.
(3)Cutting Area Definition
Definition method of the cutting area is the same as that of C–AXIS
FAPT FUNCTION.
When CAXIS REAMING or CAXIS BORING is selected as the
machining type, the cursor blinks on one of the figures listed bellow
which can be machined by these machining methods.Move the cursor
by pressing CURSOR FORWARD or CURSOR BACK soft–key
or by entering “0” (zero) and select the desired figure to be machined.
C–AXIS REAMING and CAXIS BORING can be defined for the
following figures.
End face holes defined as CAXIS figure.
Side face holes defined as CAXIS figure.
(4)Cutting Condition
Definition method of cutting conditions for machining processes other
than CAXIS REAMING and CAXIS BORING is the same as that
of CAXIS FAPT FUNCTION.
Cutting condition parameters for CAXIS REAMING and C–ACIS
BORING are explained here.
(a) C–AXIS REAMING
Enter the following cutting conditions.
CLEARANCE C1= Clearance 1 (mm or inch) (The value. . . . . . . . . .
in the system parameter No.390 is
set as initial value.)
C2= Clearance 2 (mm or inch) (The value
in the system parameter No.391 is
set as initial value.)
RPM N= Tool Rotational Speed (rpm). . . . . . . . . . . . . . . . . .
FEEDRATE FT= Feed amount per revolution of the. . . . . . . . . . . .
tool (mm/rev or inch/rev)

Leave a Reply

Your email address will not be published. Required fields are marked *