Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
8. CAXIS FAPT FUNCTION BC–AXIS FAPT FUNCTION
509
FINE BORING
TYPE TP= 1. . . . . . . . . . . . . . . . .
CLEARANCE C1= Clearance 1 (mm or inch) (The value. . . . . . . . . .
in the system parameter No.393 is
set as initial value.)
C2= Clearance 2 (mm or inch) (The value
in the system parameter No.394 is
set as initial value.)
SHIFT VALUE SH= Tool shifting distance while retracting. . . . . . . . . .
(mm or inch)
Shifting value along Xaxis for end
face boring.
Shifting value along Zaxis for side
face boring.
DWELL ON/OFF DW= Dwell at the bottom (=1) or not (=0) .. . . . . . .
RPM N= Tool Rotational Speed (rpm). . . . . . . . . . . . . . . . . .
FEEDRATE FT= Feed amount per revolution of the. . . . . . . . . . . .
tool (mm/rev or inch/rev)
(1)In case parameter TH (Through hole) is set to “0”
(2)In case parameter TH (Through hole) is set to “1”

Leave a Reply

Your email address will not be published. Required fields are marked *