Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
33
WARNING
1 Select the same material as that of the workpiece to be
machined. If a desired material option is not displayed on
the material menu, cancel the machining of the workpiece.
Failure to select the correct material may result in the
machining being performed under incorrect cutting
conditions, or the tool colliding with the workpiece and/or
machine, possibly causing damage to the machine and/or
tool itself, or injury to the user.
2 Select the blank figure corresponding to that of workpiece
to be machined. Failure to select the correct figure may
result in the tool colliding with the workpiece and/or
machine, possibly causing damage to the machine and/or
tool itself, or injury to the user.
3 Enter the correct blank dimensional data for the workpiece
to be machined. Failure to enter the correct data may result
in the tool colliding with the workpiece and/or machine,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
Soft key “1”
Go to the screen for the above processes. The meaning of each question
is as follows:
(a) MATERIAL NO MN =. . . . . . . . . . . . . . . . . . . . . . . .
This is a question for selecting the material of blank. Input the number
corresponding to the material NO. For example, key in 4 when
selecting aluminum.
3.1
BLANK AND
DRAWING (DRAWING
AND BLANK)

Leave a Reply

Your email address will not be published. Required fields are marked *